Shopping Cart
Now in Your Cart (0) Items
Browse By BroditBrowse By Categories
BlackBerry Storm Brodit Active Holder Tilt Swivel (#971875)
Product ID: Brodit 971875
Product Type: Brodit Active Holder Tilt Swivel
Product Model: BlackBerry Storm for Alla
Inc VAT : £ 49.99
Ex VAT : £ 42.54
Add to Wishlist
Also Compatible with Products
Product Details
For fixed installation with Molex adapter system. 2A charger.
Technical Detail
An active holder which is to be connected inside the dashboard, this gives a discreet, neat installation without cables hanging over the interior! The phone has got the connector for charging on the side of the device. The active holders offer a firm fit, it is easy to put the phone in the holder and then connect the charging cable to it.
You can choose to use the holder as an active holder for charging of your device only, or to connect an adapter to the Molex connector for additional features. Then you can use the holder also for power supply of a GPS receiver or other own solutions (can not be used for data communication or audio connection).
12/24 Volt. The product is E-approved. Connect the power cable with a 2 A fuse. 2 A charger. Professional installation recommended. The holder is attached onto a tilt swivel so you can easily adjust your device in order to avoid light reflection. You can also easily switch between an upright or a horizontal position, just by turning the holder. Attach onto a ProClip Mounting Platform.
Instalation Instructions
Please read all of the instructions and look at the pictures before attaching the holder. Important Note: The charger unit is fused internally with 2 A automotive re-settable thermal fuse, but if an external fuse is to be installed then connect a 2 A fuse holder and fuse inline with the Red wire close to the power source. Route the cable from the holder into the vehicle dashboard and secure the charger unit in place with the adhesive tape provided. Ensure the charger unit is securely mounted behind the dashboard in a well ventilated area that does not get hot! Note: If you are connecting a GPS/Data device to the holder please ensure the charger unit is located in a position within easy reach of any GPS or charging adapters.
Route the power cable from the charger unit to the power supply source in the vehicle and connect as follows: 1. Connect the White wire to a Negative Ground connection of the vehicle or the vehicle chassis. 2. Connect the Red wire to a 12/24 Volt power supply in the vehicle that is controlled by the ignition switch of the vehicle.
Installation of the holder: 1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back. 2. Place the attaching plate on desired position. Screw the attaching plate into place with the enclosed screws. 3. Place the holder over the attaching plate so the tilt swivel fits. Screw the holder onto the attaching plate. 4. The holder is in place.
Product Instalation Images
Shop By Make
- Home
- |
- About Us
- |
- Help
- |
- Privacy Policy
- |
- Terms and Conditions
- |
- Site Map
- |
- FAQ
- |
- Contact Us